Summit X430-48T P/N: 16518

Where can I Download Latest Software and Firmware Releases for my Extreme Products?

Log in to the Extreme Portal; Firmware can be downloaded on the Extreme Portal at the Products page; Use the Advanced button to filter by Family, Release Type, Date and other options; You can also search by file name, product name, serial number and other options; Click on the Download Name to initiate the download.

How do I access extreme switch?

Console port access via CLI. Connect to the switch's Console port using your serial cable/adapter and a terminal emulator program such as PuTTY, TerraTerm or HyperTerminal. Serial port settings are 9600 baud rate, 8, n, 1. Log into the switch using the default user. you may need to hit enter to get the login prompt.

What is ELRP in extreme switch?

ELRP (Extreme Loop Recovery Protocol) is a simple loop protection mechanism that sends a multicast packet out each configured port and checks to see if it receives it back on any port. If the packet is received back by the same switch, the port can be disabled, or the switch can notify via logs, SNMP traps, or both.

How do I turn off my extreme switch?

There is no specific way of shutting down in extreme. It's as normal as any device. Once switches are up check connectivity by doing Ping test and browse your normal applications.

How do I activate PoE on extreme switch?

PoE is enabled by default in the Extreme Networks Summit switches. If the configuration has changed, PoE can be enabled on a port by using the command “enable inline-power port”. The example below enables PoE on port 19. If the port parameter is not specified, PoE will be enabled on all the ports.

How do I enable IP routing on extreme switch?

Make sure port's are configured as untagged for end devices (PC's). configure vlan add ports untagged. Then check PC's NIC configuration for: correct IP address. correct subnet mask. correct default gateway.

How do I add a switch to stack extreme?

Verify switch to be added is running the same EXOS version and is on the same partition. show switch. Then verify that stacking protocol matches on the existing stack and the new switch. show stacking configuration. show stacking detail.

How do I update firmware on extreme switch?

Select the Devices tab in the right-panel. Select the devices for which you are upgrading firmware in the Devices table in the right-hand panel. Select the Menu icon ( ) or right-click in the Devices list. Select Upgrade Firmware.

How do I update my extreme switch?

Decide what version you want to upgrade. Download the appropriate EXOS image. Place the EXOS image on a TFTP server. Ensure that you are able to ping the TFTP server from the switch from the appropriate virtual router. Type the command download image.

How do I reset my extreme switch without a password?

Power cycle the switch while connected to the console port. When prompted, press and hold the spacebar to enter the boot rom. At the boot rom prompt, type the command config none. Type the command boot to continue the boot process.