OptiX OSN 9800 P32, Huawei OptiX OSN 9800 Series Optical Transport Subrack, Ultra-large capacity/All-optical cross-connect/Backbone core layer

View Overview of Huawei Transmission Network Hot Series

• Huawei OptiX OSN 1800
• Huawei OptiX OSN 500/550/580
• Huawei OptiX OSN 8800/6800/3800
• Huawei OptiX OSN 9800
• Huawei OptiX OSN 7500/7500 II

Quick Spec

Table 1 shows the quick spec.

Product Details

Huawei OptiX OSN 9800 P32 Chassic:

Subrack Areas and Slots

Boards need to be installed in the designated slots in a subrack. The subrack runs on -48 V DC or -60 V DC.

The equipment includes the following areas: the power supply, system control, optical supervisory, and interface area, fan area, fiber routing area, and service board area.PIU boards are located in the power supply, system control, optical supervisory, and interface area. If an area has the same background color as a PIU board, the PIU board powers the boards located in this area.

Figure 1. Schematic diagram of the areas and slots in the OptiX OSN9800 P32subrack

Table 2 shows Descriptions of the areas and slots in the OptiX OSN9800 P32subrack.

Requirements for Inserting Service Boards in a Subrack

To ensure that service grooming is normal and fiber routing is convenient, service boards must be inserted into the subrack in accordance with certain requirements.

To insert service boards into the9800 P32subrack, the following requirements must be met:

• ● The sequence of installing optical tributary boards is D->C->B->A. That is, you can insert boards in the next area only after all slots of area D are fully inserted with boards.
• ● The sequence of installing optical line boards is A->B->C->D. That is, you can insert boards in the next area only after all slots of area A are fully inserted with boards.

When the preceding board installation sequence is met:

• ● Because there are a large number of optical fibers on the front panels of optical tributary boards, to facilitate future expansion using optical fibers, install the optical tributary boardsfrom edge side to the middlein sequence. Example: During the installation in area D, if there are two OT3232 optical tributary boards, you need to select the area with the most convenient fiber routing according to the actual environment. Assume that the left-side area D is selected. Preferentially use slots IU1 and IU2, and then use slots IU3 and IU4 in sequence. Assume that the right-side area D is selected. Preferentially use slots IU16 and IU15. Other areas comply with the same rules.
• ● Because there are a few optical fibers on the front panels of optical line boards, install the optical line boards in each areafrom left to right. Example: If there are three optical line boards, preferentially install the three optical line boards in slots IU5-IU7 of area A from left to right in sequence. If new optical line boards need to be installed, install them from left to right in sequence until area A is full. Other areas comply with the same rules.

NOTE:

Slots D and C on the left and right sides are the same. There is no requirement on the sequence of installing boards in the two slots.

Figure 2. Slots for installing service boards in the OptiX OSN9800 P32subrack

NOTE:

The cable trough in the middle of the subrack is printed with the requirements for inserting service boards.

Get More Information

Do you have any question about the Huawei OptiX OSN 9800 P32

Contact us now via Live Chat or [email protected].