SFP vs. RJ45: How should we wire them respectively?

Rj45 port: Gigabit Ethernet switch’s RJ45 port is a built-in port. To connect two RJ45 port Gigabit Ethernet switches, we only need to use a super five or six cable. The following table is the specific rate and bandwidth of this connection:

SFP port: Gigabit Ethernet switch’s SFP port is in line with 1000BASE-T (IEEE 802.3ab) standard with the transmission rate of 1000 Mbps. Unlike the above RJ45 port, the SFP port of the switch must be inserted into the SFP optical module first, and then the network cable (Category 5 / Category 5 / Category 6 cable) must be used for data transmission. In addition, in the data center, local area network (LAN) and other applications, the switch’s SFP port also has 100 / 1000Mbps adaptive function. The following table is the specific situations of the SFP port:

RJ45 connection and SFP connection of Gigabit Ethernet switch 

The following figure shows the RJ45 connection and SFP connection of the Gigabit Ethernet switch. The left side is the SFP connection of the UniFi switch and the RJ45 connection is on the right side of the UniFi switch. SFP connection requires the use of two SFP electrical modules and a Cat5 cable or the use of two SFP optical modules with optical port and a fiber jumper; RJ45 connection only needs to use a Cat5 cable.

Which is better?

From the above, RJ45 port and SFP port’s performance is basically the same, but from the cost, SFP port’s cabling costs are higher. However, the SFP port is still necessary because it supports both SFP optical modules with electrical ports and optical ports. The transmission distance of the latter is much longer than that of the RJ45 port. In the practical application, it has relatively high flexibility and scalability.